priced Cisco Aironet AG Series is ready to install and easy to manage, reducing the cost of configuration information with no manual intervention. Reportez-vous au tableau suivant et aux instructions pour ouvrir le capot supérieur. Guide de démarrage rapide des points d’accès Cisco Aironet AG. The Cisco® Aironet® G Series Access Point is a single-band g access point that features configuration information with no manual intervention.

Author: Mazuramar Nelkree
Country: Azerbaijan
Language: English (Spanish)
Genre: Science
Published (Last): 5 October 2011
Pages: 241
PDF File Size: 10.72 Mb
ePub File Size: 6.53 Mb
ISBN: 962-7-35863-533-2
Downloads: 3337
Price: Free* [*Free Regsitration Required]
Uploader: Faerr

Use the Cisco Product Identification CPI tool to locate your product serial number before submitting Note a web or phone request for service. Page 42 Step 7 Attach the T-rail clips on the each end of the T-bar box hanger to the ceiling grid T-rails.


These documents are also available on Cisco. When using the access point browser interface, you should disable your browser pop-up blocker. An Enter Network Password screen appears. If required, configure the power settings as described in the previous section. Page 22 AC power adapter No configuration requirement 1.

Page 46 Warranty Statement, including the warranties and license agreements applicable to Cisco software, is available on Cisco. Enter the username Cisco in the User Name field.


Don’t have an account? Comments to this Manuals Your Name. Manufacturers Federal Communication Commission Declaration Of Conformity Statement The Part 15 radio device operates on a non-interference basis with other devices operating at this Caution frequency when using the integrated antennas.

The appendix contains the following sections: Figure shows an access point acting as a repeater. To disable command history for the line, enter the no history line configuration command. Each Cisco switch should be upgraded to support Intelligent Power Management.

Cisco Aironet 1130AG Quick Start Manual

Cisco access points use hexadecimal characters. Aironet extensions must be enabled to support A connector type unique to Cisco Aironet radios and antennas. Enter a question mark?

ciaco Table of Contents Add to my manuals Add. Verify all the package contents, and inspect each item for damage. It centrally identifies and configures access points in customer-defined groups and reports on throughput and client associations. Dual antennas used for diversity operation are not considered co-located.

If you press Esc Y more than ten times, you cycle to the first buffer entry. For more details, contact Cisco Corporate Compliance.

Page of 49 Go. This device must accept any interference received, including interference that may cause undesired operation.


Step 4 Remove the key. The buffer contains only the last 10 items that you have the last ten items that you deleted. Troubleshooting Low Power Condition On power up, the access point is placed into ciscl power mode both radios are disabledCisco IOS software loads and runs, and power negotiation determines if sufficient power is available.


Page The body responsible for the Ethernet The access point supports the IEEE Page – Manufacturers Federal Communication Comm Table of Contents Add to my manuals Add. Page 33 Mankal to eliminate the conflict. If you need to continue configuring the access point using Telnet, use the new IP address to open another Telnet session to the access point.

Page The text name that refers to a grouping of networks or network resources based domain name on organization-type or geography; for example: The logo should always be easy to read. Warranty Aronet, including the warranties and license agreements applicable to Cisco software, is available on Cisco.

Page 47 Push down on the padlock to ensure the padlock is held by the security hasp adapter clips. IP ciwco and shared secret for an authentication server on your network server authentication port