AN899 MICROCHIP PDF

Read about ‘Microchip: AN – Application Note for Brushless DC Motor Control Using PIC18FXX31 MCUs’ on elementcom. Microchip. leader in motor control, Microchip is continuously designing new motor .. AN Brushless DC Motor Control Using PIC18FXX31 MCU’s. AN Sensorless. AN Brushless DC Motor Control Using PIC18FXX31 MCUs. Author: Padmaraja Yedamale Microchip Technology Inc. HARDWARE A PICDEMâ„¢ MC demo.

Author: Faezshura Zologore
Country: Swaziland
Language: English (Spanish)
Genre: Education
Published (Last): 7 June 2017
Pages: 72
PDF File Size: 8.33 Mb
ePub File Size: 15.21 Mb
ISBN: 891-2-72468-719-3
Downloads: 70988
Price: Free* [*Free Regsitration Required]
Uploader: Nezragore

Motorboard Controller Source Code (Open Source) – Motorboards

This prevents power from being applied to the motors until they are at least rotating at 3mph. The controller monitors the speed of one of the motors the one with a optical wheel “chopper” attached to an elongated motor shaft.

The motor makes approximately Privacy policy About Motorboards Disclaimers Mobile view. One turn of the wheel is at best inches The Roth motorboards “maximum” speed of 18mph translates to optical pulses per second. If the speed of this motor is less than 3mph, no power will be provided to the motors. The motorboard will not function and there will be no indication as to the cause of failure.

  ASTERIX ET OBELIX MISSION CLEOPATRE PDF

Navigation menu Personal tools Create account Log in.

Actually it operates at Hz measured. Views Read View source View history. Then the operator pushes to go.

The current code cannot be read because the “Code Protect” bit mucrochip been set, but it is possible to erase the chip and program it with new code. When the battery gets critically low, the RED light will illuminate.

Motorboard Controller Source Code (Open Source)

Retrieved from ” http: The motorboard has an automatic low power shut off. This saves significant amounts of battery power and prevents the motorboard from starting accidentally. If low power is detected the red LED will blink, and power will be shut off completely.

The speed is controlled linearly, and no attempt micorchip made to maintain a given speed for a given throttle position. When the battery is almost dead, the red light will blink and the buzzer on the motor contoller PCB will beep on and off 1 second on, 4 seconds off until the battery reaches the low power shut off.

  KALTIMPOST HALAMAN PDF

Because there is no indication that the motor is moving less than 3mph, if the optical wheel fails for any reason the motorboard will assume that 3mph has not yet been reached. Since there are eight optical slots on the chopper per turn, this means optical pulses per turn of the wheel.

When you turn the motorboard ON, the green light goes on then off, then the yellow light goes on then off then the red light goes on then off and then the green light goes on solid. This page was last modified on 23 Marchat